back
Proffieboard V3
Got Pike?
Configuration generator


Select your configuration below. Note that while this tool can show many different configurations for the Proffieboard, there are many many more possible configurations.
Blades / LEDs Blade options Buttons Other
Number of LEDs: RGBW ZigZag Blade Detect
Number of LEDs: RGBW ZigZag
Resistor:
Resistor:
Resistor:
Resistor:
Resistor:
Resistor:
Resistor:
OLED Display / PLI Charge Port
Number of LEDs: RGBW ZigZag
Number of LEDs: RGBW ZigZag Parallel
Number of LEDs: RGBW ZigZag
Number of LEDs: RGBW ZigZag Parallel
Resistor:
Resistor:
Resistor:
Resistor:
Resistor:
Resistor:
Bluetooth: Kill switch
Number of LEDs:
Number of LEDs: RGBW
IR receiver Reverse orientation
image/svg+xml + 3.7 volt li-ion - 470 ohm ??? ohm ??? ohm ??? ohm ??? ohm ??? ohm ??? ohm ??? ohms ??? ohm ??? ohm ??? ohm ??? ohm ??? ohm ??? ohm
Config file, cut-and-paste this into a new file called my_saber1.h, then follow the instructions on the software page.

Troubleshooting
If you're having problems, check out the troubleshooting page.

Problems? Questions? Suggestions? Check out The Crucible.
This page has been accessed 28,576 times since May 27th, 2021.
Last modified: June 3rd, 2021 - Design by Monica & Fredrik Hübinette